Equinox Replacement Battery 3011-0405
Equinox Replacement Battery 3011-0405
Genuine Minelab EQUINOX Battery Replacement
Replace the EQUINOX Series internal Li-Ion battery.
Due to the waterproof design of EQUINOX Series detectors it is strongly recommended you read all instructions prior to commencing the battery replacement.
A video demonstrating the replacement process can be found on the Minelab YouTube Channel at this link: EQUIONX Battery Replacement Video
Overview
- Detector: EQUINOX Series
- Difficulty: Easy
- Time Required: 10 mins
- Hazards: Water Ingress
- Hex Driver 3mm
- Hex Driver 2mm (H2)
- Needle Nose Pliers
Step 1
Access the battery compartment
Step 2
Remove the battery
Do not extract the wiring loom connector beyond the entrance of the battery compartment as doing so may cause irreparable damage to the Control Pod.
Step 3
Prepare new battery for installation
Two O-rings are present and free from dirt & grit.
Gore vent [8] is present and undamaged. Do not touch or tamper with the bung assembly gore vent [8].
Step 4
Replacement battery installation
The battery and bung assembly should enter the Control Pod easily without significant resistance.
The final 5mm of the battery assembly insertion may require additional force.
It is critical that the bung is positioned symmetrical into the handle. If the bung is asymmetrical, this may lead to water ingress!
The torque should not exceed 0.5 Nm
Ensure the bung does not move when tightening the screw and the bung is still positioned symmetrical into the handle when tight.
Step 5
Reassembly
The torque should not exceed 1.0 Nm
Share
Subscribe to our emails
Be the first to know about new collections and exclusive offers.